[摘要]1、为避免机器在运输、装卸等环节中出现意外，使用前必须检查各部位螺栓、螺母是否松动，扁齿，圆齿，主轴螺母有无松动现象。用手转动皮带轮，检查机器有无碰撞现象。
告诉您饲料搅拌机使用安全注意事项。
大家对于应该不是很陌生，今天我们再为您拓展一下相关知识，为大家介绍的是更多相关内容，跟随我们一起看一下吧：
1、为避免机器在运输、装卸等环节中出现意外，使用前必须检查各部位螺栓、螺母是否松动，扁齿，圆齿，主轴螺母有无松动现象。用手转动皮带轮，检查机器有无碰撞现象。
To avoid unexpected machine in the transport, handling and other sectors in various parts of the bolts must be checked before use, the nut is loose, flat teeth, round teeth, spindle nut without loosening. Rotate the pulley, check the machine whether the collision phenomenon.
2、机器转动是否灵活，机内是否有杂物，开机空转3分钟，无异常现象，才能开始操作。
Turn the machine is flexible, if there is debris inside the machine, turn idle 3 minutes, no abnormal phenomenon, to begin operation.
3、工作时一定要注意清除物料中的杂物，严禁铁块石头等物进入机器，以免损机伤人，接料布袋应有4米以上长度，直径0.6米，布料不能过密，使用中要及时出料，保证布袋有足够的透气性。
Work must pay attention to remove material in the debris, stones and other objects prohibited iron into the machine, so as not to damage machine wounding, then there should be four meters above material bag length, 0.6 meters in diameter, the fabric is not too close, use should be promptly the material to ensure that the bag has sufficient permeability.
4、喂料要均匀，注意动力的负荷程度，免以噎住。粉碎颗粒物时可用抽板调节器节喂入量，当一角磨损影响工作效率时，可将锤片反面调头(调头时4组一次一起调，以免引起转子不平衡)更换锤片应全部更换。
Feeding should be uniform, pay attention to the extent of the power load, free to choke. When crushed particles available pumping plate section feed rate regulator, when worn affect the efficiency of the iceberg, you can turn around and reverse hammer (a tone when a U-turn four groups together, so as not to cause the rotor unbalance) to replace the hammer should all be replaced.
5、每天开机前应加注黄油，使用500小时应检查轴承状况，安装筛片时有毛刺一面应装在上面。根据粉碎物料的细度，选择不同直径筛孔的筛片。
Before starting the day should bear butter, use 500 hours should check bearing condition, installation piece burr side of the screen should be mounted on top. According to the fineness of the crushed material, choose a different diameter mesh sieve.
看完以上关于的行业资讯，相信里面一定会有您需要的内容。