安阳支架泳池厂家把维护方法悄悄告诉你

　　安阳支架泳池厂家把维护方法悄悄告诉你

　　现如今，相当火爆，它满足了广大游泳爱好者的要求，不仅适合大人，更适合孩子。如果你想经营支架游泳池，就来看看安阳支架泳池厂家分享的这个维护方法吧。

　　step1、排干的水，然后放掉边缘气室的气体，作清洁处理。剪取修补片。修补片要剪成修补区域的3倍大小，应为圆形或椭圆形。

　　step2、先打底胶处理。把需要修补的区域和修补片擦拭干净，均匀涂上专用胶水，然后使用电吹风吹到不粘手，自然风干也可以。

　　step3、打补胶处理。把刚才干了的修补区域和修补片再次均匀涂上专用胶水，同上处理至不粘手。

　　step4、粘合。把修补片对准的修补区域，从一方向缓慢贴上，注意不要产生气泡，然后用手压平整。

　　step5、压牢。粘好后放于平整硬物之上，上面加上平整重物压制24小时后即可使用。

　　Nowadays, stent swimming pool is quite hot, it meets the requirements of the majority of swimming enthusiasts, not only for adults, more suitable for children. If you want to run a stand swimming pool, take a look at the Anyang pool pool manufacturers to share this maintenance method.

　　Step1,support and drained the swimming pool water, gas and drop edge of the gas chamber, cleaning. Patch. Patch to cut into the patch area 3 times the size, should be round or oval.

　　Step2, the first rubber processing base. The need to repair areas and patches wipe clean, evenly coated with special glue, and then use electric hair blowing to non stick hands, natural air drying can also be.

　　Step3, hit and repair plastic processing. Apply the special glue to the repaired area and patch once again, and deal with the non stick hand.

　　Step4, adhesion. Align the patch to the repair area of the bracket swimming pool, slowly sticking from one direction, pay attention not to generate bubbles, and then flatten by hand.

　　Step5, press firmly. After sticking on the flat hard objects above, plus the formation of heavy objects to suppress after 24 hours can be used.