珠海通风降温设备厂家和你分析隧道通风设备的安装

珠海通风降温设备厂家和你分析隧道通风设备的安装

     厂家，专业生产环保空调、各种风机、降温水帘、通风降温设备，面向车间、工厂、酒店等地进行施工降温工程，联系方式：***（韩）

    今天东莞市华钛制冷设备科技有限公司和大家分享隧道通风设备的安装，如下：
    第一、隧道通风风机安装
    为了保证压入较好的新鲜空气，风机安装于洞外距洞口约1Om处，为了使运转平稳，用混凝土浇筑机座，将通风设备固定在上面，并用螺杆连接牢固。通风降温工程公司表示为了防止通风设备和配电柜雨淋受潮及防止他人触电发生意外，在风机和配电柜上方搭盖雨棚和护栏。
    第二、隧道通风风管悬挂固定
    风管与风机连接处用铁皮加工喇叭口，一头用螺栓与风机连接，另一头套上强力胶管，用铁丝捆绑加固。大风管悬挂在二次衬砌墙体上，约离地面3m高。挂设风管要平顺直。通风降温工程公司指出作业时，先每隔5二打眼，安装短锚杆或膨胀螺栓，然后用bmm铁丝拉线，用紧线器张紧，风管吊挂在拉线下口风管悬吊要稳固，高度一致，要求每lom挠度不大于150二ma
    第三、隧道通风效果
    指出大尖坡隧道左、右线都采用大功率通风机压入式通风，满足了施工生产的需要，增强了通风效果，缩短了通风时间。
Zhuhai ventilation cooling equipment manufacturers, specializing in the production of environmental protection, air conditioning, fan, cooling water curtain, ventilation cooling equipment, for the workshop, factories, hotels and other construction cooling project, contact: *** (South Korea)
Today, Dongguan City, China Titanium refrigeration equipment Technology Co., Ltd. and share the installation of tunnel ventilation equipment, as follows:
First, tunnel ventilation fan installation
In order to ensure the pressure into the good fresh air and fan installed in the cave from the cave of about 1Om, in order to enable a smooth operation of the ventilation equipment, concrete frame, the ventilation equipment fixed on the top, and with a screw connected firmly. Ventilation and cooling engineering company in order to prevent the ventilation equipment and power distribution cabinet rain moisture and prevent others electric shock accidents, in fan and a power distribution cabinet above take cover canopy and guardrails.
Second, tunnel ventilation duct suspension fixed
Wind tube and the wind machine connection with metal processing bell, a head with bolts and fan connection, another caps on the strength of the hose, wire binding reinforcement. The wind pipe is hung on the wall of the two lining wall, about the height of the ground 3m. To hang a wind pipe to ride a ride. Ventilation cooling engineering company pointed out the homework, first every 5 second drill, installation short bolts or expansion bolt, then with BMM wire cable, with a tight line tensioner wind pipe hanging in the cable lipped tube suspension to a solid, highly consistent, requirement each LOM deflection is less than 150 mA
Third, tunnel ventilation effect
The ventilation and cooling engineering company pointed out that the large power fan is used in the left and right line of the tunnel to meet the need of construction production, enhanced the effect of ventilation, and shortened the time of ventilation.